SAZ-2000D

Our SAZ-2000D model is based on the highly regarded SAZ-1500D design but is beefed up with more of all critical parts; more MOSFETs, larger transformers, larger output inductors, and so on in order to produce even more power! If you are looking for a bit more output than the SAZ-1500D but an SAZ-3500D is simply too much power then this is the amp for you.

 This amplifier was designed from the ground up to exceed all consumer expectations. From the huge 1/0 gauge power input terminals to the heavy duty heat-sink, this amplifier is built for power. The SAZ-20000D isn't just built for power though, it was designed for the discerning listener who needs hefty amounts of power for subwoofer duty -- it is just as much at home in an install meant for listening pleasure as it is in an all out SPL machine.

We do recommend a high output alternator when using the SAZ-2000D model.

SPECIFICATIONS:

  • Digital Class-D Linkable Mono Block Amplifier
  • Double Sided Through Hole Epoxy PCB
  • 1 Ohm Stability
  • Daisy-Chain Through Output RCA
  • Efficiency : 86% @ 4 ohm, at 100Hz
  • 24dB/Oct Variable Crossover
  • Multi-Way Protection Circuitry
  • (Thermal/Over Current/Speaker Short/Speaker DC Protection)
  • RCA Line Input and Master Output
  • 24dB Octave Crossover Slope
  • 24dB Octave Variable Subsonic Crossover Slope
  • Variable Bass Boost
  • Variable Low Pass Filter
  • Variable Phase Shift
  • Zero(0) Gauge Power Supply Connectors
  • Tested Voltage & THD : 14.4V & Less than 1% THD
  • Operating Voltage : DC 10V~18V
  • Wired Remote Controller
  • MSRP $899 USD
Rated power output  

----RMS power, 2 ohm linkable/dual mono

4000W x 1CH

----RMS power, 1 ohm mono

2000W x 1CH
----RMS power, 2 ohm mono 1000W x 1CH

----RMS power, 4 ohm mono

500W x 1CH
Signal to Noise Ratio >90dB
Low pass frequency crossover 35Hz~300Hz
Subsonic filter 10Hz~60Hz
Bass boost @ 45Hz 0~6dB
Phase shift control 0~180 degree
Frequency response 10Hz~350Hz (+/- 1dB)
T.H.D @ 4 ohm <0.1%
Efficiency @ 4 ohm 86%
Fuse rating 200A (external type fuse)
Input Sensitivity 200mV to 6V (+/- 5%)
Dimensions 252(W) x 58(H) x 434(L)mm